Fujitsu D3161-A, D3161-B, D3162-A, D3162-B BIOS 1.11.0
Previous released BIOS version
R1.3.0
BIOS Rev. 1.11.0
List of changes
- Implemented new memory reference code.
- Fixed problems with nVidia NV GT630 graphics controller.
- Fixed: When no USB3.0 driver was installed USB2.0 devices were not recognized from Windows 7 on USB3.0 ports.
- Fixed: After multiple attempts to run EFI shell the system hang.
- Added support for complex passwords via internal BIOS interface.
- Reset BIOS Setup settings to default values via plugged BIOS Recovery flash jumper without any plugged USB boot device.
- New System Management firmware (Theseus v1.26) implemented. AC power cycle necessary for activation.
- Fixed: Displayed version of video BIOS was not correct within the graphics driver.
- Fixed: After soft reset wrong memory information was shown on BIOS Setup info page.
- BIOS setup setting “Intel TXT Support” at “Advanced – Intel TXT Configuration” submenu grayed out if TPM is not available.
- Microcode updates added (SandyBridge D2/Q0).
- AMT floppy redirection is now working correctly.
- Fixed: System hangs when booting UEFI Red Hat Linux OS with network cable plugged in.
- GABI (Global Application BIOS Interface) updated.
Known problems and restrictions
- USB keyboard power button not working reliable at USB 3.0 ports.
- System not booting with limited "Active Processor Cores" at BIOS Setup.
- BIOS Setup item "Power Failure Recovery: Disabled" not working as expected with "Low Power Soft Off: Enabled".
- When clearing passwords (Administrator/User Password), passwords are not cleared when afterwards "Optimized Defaults" are loaded.
- Some automatic system PowerCycles may occur after BIOS update.